Melody / Help / Process / Router
Router
Multiband splitter / Router — fans ONE signal into LOW / MID / HIGH frequency bands, each on its own output port, so you can process the bands separately (a compressor on the lows, a de-esser on the highs, a chorus on the mids) and recombine them at a mixer. The two crossover dials set the band edges (Low×Mid and Mid×High). The FULL (unsplit) signal stays available on the main output. The kernel owns the crossover frequencies; audio.js realises the filter split (the same from_output port seam the arranger's group buses use). Slice C-1 of the Router/Filter node — a rule-based matrix mode (route which sources / bands go where) grows on this.
Inputs
| Port | Signal |
|---|---|
| In | audio · audio |
Outputs
| Port | Signal |
|---|---|
| Full | audio · audio |
| Low | audio · audio |
| Mid | audio · audio |
| High | audio · audio |
Parameters
| Parameter | Range | Default |
|---|---|---|
| Low×Mid | 40 – 1000 Hz | 250 |
| Mid×High | 800 – 12000 Hz | 2500 |
More process nodes
3-Band EQ · 3D Orbit · 3D Spatial · Amp Model · Auto-Pan · Band-pass Filter · Bitcrush · Buffer Stutter · Cabinet · Chorus · Compressor · Delay